Bell helicopter has now attached the wing to the fuselage of a new, next-generation tiltrotor aircraft engineered to reach speeds of 280 knots, fly for 800 kilometers on one tank of fuel, hover and maneuver in “high-hot” conditions and function as both a utility and attack helicopter platform.

The intention is to build an advanced, high-tech tiltrotor demonstrator aircraft to take flight in November of 2017 as part of an effort to ultimate build a future aircraft able to begin operations in the 2030s.

“There is one long wing. We attach the middle of the wing to the fuselage - the entire wing is one piece bolted to the fuselage of the airplane. One wing covers both sides. The wing is attached with aircraft grade structural fasteners. There are enough aircraft fasteners to provide sufficient strength to hold the aircraft together,” Vince Tobin, Vice President of Advanced Tiltrotor Systems, Bell Helicopter, told Scout Warrior in an interview.

The new Bell tiltrotor, called the V-280 Valor, is part of the Army’s Joint Multi-Role Technology Demonstrator program aimed at establishing requirements and paving the way toward a new Future Vertical Lift aircraft designed to meet a wide range of new requirements.

The concept behind the Army’s joint Future Vertical Lift program is to engineer a forward-looking, future aircraft able to reach airplane speeds and yet retain and ability to hover and maneuver like a helicopter.

 “The aircraft will have an ability to come to a hover in challenging conditions and then, while at a hover, operate at low speeds with maneuvering capability to roll and yaw. We want it to have the handling perspective to make the aircraft able to do what it is able to do,” Tobin added.

In addition, the future aircraft is intended to be able to use fuel-efficient engine technology to allow an aircraft to travel at least 800 kilometers on a single tank of fuel. Such an ability will enable the aircraft to operate more easily one a single mission without needing Forward Arming and Refueling Points, or FARPs.

The idea is to engineer and aircraft able to fly from the west coast to Hawaii without needing to refuel.

(This piece first appeared in Scout Warrior here.)

“FVL is a high priority. We have identified capability gaps. We need technologies and designs that are different than what the current fleet has. It will carry more equipment, perform in high-hot conditions, be more maneuverable within the area of operations and execute missions at longer ranges,” Rich Kretzschmar, project manager for the FVL effort, told Scout Warrior in an interview several months ago.

Requirements for the program are still being refined for the Army-led program, which is aimed at service future aircraft for all four services.

These requirements, now being put into actual demonstrator aircraft built by both Bell and a Boeing-Sikorsky industry teams, include building and aircraft able to reach speeds greater than 230 knots, hover in thin air at 6,000-feet and 95-degrees Fahrenheit, achieve a combat radius of at least 434 kilometers and be configured to include emerging sensors and mission equipment technologies likely to emerge by the 2030s.

“We had set 230 as the speed requirement because we wanted to push the technology.  We wanted people to bring new ideas and new configurations to the table,” Dan Bailey, JMR TD Program Manager, said in an interview with Scout Warrior several months ago.

 Advancing Tiltrotor Technology

 Bell intends to build upon and advance existing tiltrotor technology such as that which is currently operation in the Bell-Boeing V-22 Osprey aircraft. The Osprey continues to perform well in a wide range of missions and has recently been selected by the Navy to perform the Carrier On-board Delivery or COD mission transporting troops, equipment and weapons on-and-off surface ships. 

The V-280 Valor is designed to be slightly bigger than an existing Black Hawk helicopter and use 24-inch seats to carry 11 passengers with gear, Tobin said.

 “What Bell has done is taking its historical V-22 aircraft, and all the demonstrators before that, and applies them to this next-generation tilt-rotor. It is a straight wing versus a V-22 which is not straight. This reduces complexity,” Bailey explained. “They are also building additional flapping into the rotor system and individual controls that should allow for increased low-speed maneuverability.”

The tiltrotors are slated to go on in November, Tobin added.

“We will get the gear boxes and transmission in before we get those blades on,” Tobin explained.

Depending upon ultimate requirement established by the Army and DoD, Bell expects to engineer an attack variant of the aircraft with a slightly different fuselage configuration.

“An armed attack version will have a gun, 2.75in folding-fin rockets and some type of point-to-point missile - hellfire or some later generation missile that would guide off of a laser or IR. We are being open ended in that we are not designing any specific requirement,” Tobin explained.

 Next-Generation Sensors

The new attack variant is expected to use a modernized or next-generation of existing Apache sensors and targeting systems called the Modernized Target Acquisition Designation Sight/Pilot Night Vision Sensor, or MTADS/PVS.

When it comes to sensors and mission equipment, Bell engineers are building a tiltrotor aircraft with what is called “open architecture,” meaning software and hardware able to quickly integrate new technologies as they emerge. The concept is to construct a helicopter that is not intended to operate today but rather advance technology well into the 2030s and beyond. Therefore, it will need to anticipate the weapons, sensors, computer processors and avionics likely to emerge by the 2030s.

Part of this effort includes the integration of a 360-degree sensors suite quite similar to the one used on the F-35 Joint Strike Fighter called a Distributed Aperture Systems, or DAS.

“Instead of having sensors mounted to the turret, you have sensors that are mounted to the aircraft – so essentially you have sensors staring in 360-degrees around the aircraft at any given time. Those images are stitched together so it appears as one continuous image to the pilot. Both pilots can make use of the same system,” Tobin said.

This technology will also allow troops riding in the back of the aircraft to wear goggles or a helmet giving them a view of the surrounding sensor feeds as they transit to a mission, Tobin added.

The DAS system will also form the basis a small-arms enemy fire detection technology which will search for and locate the signature of incoming enemy attacks. The sensors will be able to discern the location and heat signature coming from enemy small arms fire, giving the aircraft and opportunity to quickly attack with its weapons – lowering risk of injury to the pilots, crew and passengers.

The V-280 Valor will also have yet-to-be-determined Degraded Visual Environment technology that allows sensors to see through obscurants such as brown-out conditions, bad weather and other impediments to navigation. Part of this will also include a system called Controlled Flight into Terrain wherein an aircraft has an ability to quickly re-route itself it is approaching a dangerous obstacle such as a mountain, rock wall or building structure.

This will likely draw upon a semi-autonomous navigation technology built into the aircraft known as “fly-by-wire.”  Bell Helicopter developed the initial algorithms for this technology, which is also now on the V-22 Osprey.

Another survivability technology potentially slated for the aircraft is a system known as Common Infrared Countermeasure, or CIRCM; CIRCM is a lighter weight variant of an existing technology which uses a laser-jammer to throw incoming enemy missiles off course – therefore protecting the aircraft.

"We are looking to the DoD customer to see what they want. Either way we can get that on the airplane,” Tobin explained.

Kris Osborn became the Managing Editor of Scout Warrior in August of 2015. His role with Scout.com includes managing content on the Scout Warrior site and generating independently sourced original material. Scout Warrior is aimed at providing engaging, substantial military-specific content covering a range of key areas such as weapons, emerging or next-generation technologies and issues of relevance to the military. Just prior to coming to Scout Warrior, Osborn served as an Associate Editor at the Military.com. This story originally appeared in Scout Warrior. 

Image: Bell Helicopter